Smart Cities - Foundation Licence Practise Exam 1

From Sensors in Schools
Jump to navigation Jump to search

1. All equipment connected to the mains supply should have:-

  • a) an electricity authority approval label
  • b) an extra fuse in the cable
  • c) the leads uncoiled only as far as necessary
  • d) a residual magnetic circuit Doppler for safety


2. If a 13.8 volt 10 Amp fuse continues to blow when replaced then:-

  • a) a bigger fuse should be used
  • b) a larger current rating fuse be used but not greater than 50% more than original fuse
  • c) a fuse with next biggest current rating used
  • d) help of an authorised repairer or other competent person should be sought


3. EMC problems can be minimised by:-

  • a) placing the transmitting antenna as far as possible from the affected equipment
  • b) increasing the transmitters modulation
  • c) having an Advanced licence
  • d) increasing transmitter power to swamp the interference


4. An electric fuse prevents:-

  • a) the need for a residual current detector
  • b) excessive current and possible fire or heat damage
  • c) excessive transmitter power
  • d) excessive voltage and reduces the possibility of shock


5. VHF and UHF transmissions are considered to require an obstacle free path between transmitter and receiver, this is called:-

  • a) long path
  • b) short path propagation
  • c) ionospheric reflection
  • d) line of sight propagation


6. The primary intent of Amateur radio is to facilitate:-

  • a) prevent the need for using the public telephone system
  • b) weather warnings to ships at sea
  • c) a recreational hobby in radiocommunications
  • d) large network of skilled radio listeners


7. Interference from an amateur station that disrupts a commercial radiocommunication service is called:-

  • a) commercial interference
  • b) harmful interference
  • c) disruptive interference
  • d) radiocommunications overload


8. If a radio amateur hears a distress call, on a non-amateur frequency, that is not acknowledged, the radio amateur:-

  • a) if there is no response, respond and provide assistance using whatever means available, and using radio if equipment allows
  • b) should continue to monitor and call other stations on a different band
  • c) should urgently endevour to find anyone who can operate on the frequency of the distress
  • d) may not transmit and contact the appropriate emergency authority


9. The diagram below that closely represents output of a sinewave oscillator is:-

  • a) diagram A
  • b) diagram B
  • c) diagram C
  • d) diagram D


10. Documentation that contains the latest statutory rules pertaining to the operation of an Amateur radio station is:-

  • a) The Australian Radio Amateurs Band plan (ARABP)
  • b) The Foundation Licence Manual
  • c) The WIA callbook.
  • d) The Radiocommunications Act 1992 and the Licence Conditions (Amateur Licence) Determination


11. As the licensed operator of your station it is your responsibility to:-

  • a) prevent unauthorised operation of your station by any suitable means
  • b) disconnect all power leads and antennas when leaving
  • c) remove all the microphones from transmitting equipment
  • d) prevent unauthorised operation of your station by locking the station doors and any other entry points

12. A radio call that includes PAN PAN means:-

  • a) that the call is via the Internet
  • b) a Distress situation
  • c) that the call is for a specific country
  • d) an Urgency situation


13. An AM transmitter is likely to over modulate if the:-

  • a) microphone gain control is set too high
  • b) RF gain control is set too high
  • c) IF gain control is set too high
  • d) LF gain control is set too high


14. If a battery is burnt or punctured, it may:-

  • a) implode
  • b) explode
  • c) electrode
  • d) polarise


15. If interference to other radio services is being generated by a Foundation station, the Foundation station licensee must:-

  • a) cease all transmissions
  • b) deny responsibility and keep operating
  • c) surrender the station licence to the Australian Communications and Media Authority
  • d) advise a full-call operator


16. An amateur transceiver that is being over modulated may result in:-

  • a) interference to other services
  • b) an increase in the feedline loss
  • c) improved signal reports
  • d) a reduction of power output


17. If the antenna elements are horizontal with respect to the ground the antenna would normally be considered to be:-

  • a) cross polarised
  • b) vertically polarised
  • c) circular polarised
  • d) horizontally polarised


18. Using the correct formula, calculate the power in a circuit when a 25 ohm resistance has 2 amperes of current going though it:-

  • a) 50 watts
  • b) 12.5 watts
  • c) 156.25 watts
  • d) 100 watts


19. Long distance radio communication in the range 3-30 MHz mostly relies on:-

  • a) tropospheric refraction
  • b) faraday bounce from the upper atmosphere
  • c) tropospheric diffraction
  • d) ionospheric refraction


20. If an amateur is causing harmful interference to other radiocommunications services, the amateur must:-

  • a) put in a mains filter
  • b) reduce power
  • c) cease transmission immediately
  • d) review the transceiver user manual


21. The purpose of the amateur radio service is primarily:-

  • a) to avoid using the Internet for communication
  • b) for self training in radiocommunications and technical investigation
  • c) to save on telephone bills
  • d) for the entertainment of other amateurs


22. EMC problems can be minimised by:-

  • a) careful selection and location of antennas
  • b) increasing transmitter power to swamp the interference
  • c) having an Advanced licence
  • d) only transmitting after midnight


23. Referring to the following diagram (waveforms), which diagram represents a normal FM signal:-

  • a) diagram 2
  • b) diagram 3
  • c) diagram 1
  • d) diagram 4


24. Referring to the following conversion chart, the approximate size of a half wavelength antenna to be used at 148 MHz is:-

  • a) 70cm
  • b) 1m
  • c) 20 metres
  • d) 160m


25. The most likely locations for filters used to reduce interference are in the:-

  • a) antenna cabling and power supply
  • b) modulator
  • c) RF amplifier, oscillator and IF amplifier stages
  • d) oscillator, buffer stages


Answers

  • 1 - A
  • 2 - D
  • 3 - A
  • 4 - B
  • 5 - D
  • 6 - C
  • 7 - B
  • 8 - A
  • 9 - A
  • 10 - D
  • 11 - A
  • 12 - D
  • 13 - A
  • 14 - B
  • 15 - A
  • 16 - A
  • 17 - D
  • 18 - D
  • 19 - D
  • 20 - C
  • 21 - B
  • 22 - A
  • 23 - B
  • 24 - B
  • 25 - A