Tiny House project - Jeremy

This box is used to test the thermal performance of a model Tiny House

Photo/Video Library

Photo/Video Album

MakerCase 580*580*580 Close box SVG file

Go to MakerCase

Click on Simple Boxes

Change Units to Millimeters

Change With to 580 Change Height to 580 Change Depth to 580

Ensure Outside is selected for Are these inside or outside dimensions?

Ensure Material Thickness is 3mm

Ensure Open or closed box? is Closed

Change Edge Joints to Finger and set Finger Size to 51

Your settings should look like this

Then select Download Box Plans

You should see a pop-up with this picture in it

Adjust Line And Spacing settings to match the ones below

Adjust Line Formatting settings to match the ones below

Adjust Kerf settings to match the ones below

Then select Download SVG

Finally rename the downloaded file to something better/more suited

Inkscape Editing

Open the aforementioned file in Inkscape and proceed to do the following things (Download Inkscape)

In Inkscape change view mode to View -> Display Mode -> Outline so you can see the box sides

Create 6 pages with the dimensions 600*600mm by selecting the Create and edit document pages icon in the left toolbar

You can also add labels to the pages

All 6 pages

Align the 6 pages

Select the design then select Object -> Ungroup

Align separate sides onto their own page

Delete labels

Optionally after deleting the labels add smaller 1-2 letter labels in the corner of each side

Add access square with the dimensions 131*131mm to the to-be front panel

Center the square on the front panel

Set Stroke Style to 0.01pt on all objects

Change Stroke Paint

Insert Creation

Go to MakerCase

Click on Simple Boxes

Change Units to Millimeters

Change With to 574 Change Height to 180 Change Depth to 180

Ensure Outside is selected for Are these inside or outside dimensions?

Ensure Material Thickness is 3mm

Ensure Open or closed box? is Closed

Change Edge Joints to Finger and set Finger Size to 30

Your settings should look like this

Then Select Download Box Plans

And edit the parameters to be the same as below

Then select Download SVG

And rename to something better/more relevant

Editing insert in Inkscape

Open the file in Inkscape

Add new page and size to fit

Rearange with new page

Remove labels

Edit Stroke Style

Add 131*131mm cutout

Final SVG files

Main Box

Box Insert

Laser Cutting

Put SVG files into your laser cutter software

Then Cut!

Video Of Laser Cutting

Assemble Laser Cut Side Panels

Connect all side panels into their according locations and stick together

Add top panel but DON'T STICK DOWN (For Later Access)

Adding Insert

Assemble and add insert without sticking down

Creating Sensor Board

Solder in place in order

The tape is just to relive the solder joints of stress (because my battery holder solder joint disconnected)

Final Sensor Board

Programming The Pycom LoPy 4

Tests

import pycom from time import sleep

pycom.heartbeat(False) pycom.rgbled(0x0000ff) #green

sleep(2)

for cycles in range(10):

   pycom.rgbled(0x00ff00) #green
   sleep(2)
   pycom.rgbled(0xffff00) #yellow
   sleep(2)
   pycom.rgbled(0xff0000) #red
   sleep(2)

sleep(2) pycom.rgbled(0x000000) #off