Victron MPPT data using Arduino serial

References

• Reading Victron MPPT controller data using Arduino
• Example code
• VE.Direct Protocol Document

Parts Required

• Victron BlueSolar MPPT 75/15 Retail SCC010015050R - $135 (Note that this unit is not Bluetooth enabled) [1]
• JST Jumper 4 Wire Assembly - $2.75 [2]
• Arduino Uno

Voltage considerations for different Victron hardware

• Victron MPPT operates at 5V.
• Arduino Uno also operates at 5V so no digital converter required.

VE.Direct Pinout

Photos of Circuit

Arduino Code - Image

Serial Monitor - Example Output

Arduino Code - Code

/* Connections:
    MPPT pin     MPPT        Arduino     Arduino pin
    1            GND         GND         GND
    2            RX          TX          -              do not use!
    3            TX          RX          7 (UNO)
    4            Power+      none        -              do not use!
 */

#include <SoftwareSerial.h>

SoftwareSerial mySerial(7, 8); // RX, TX

String label, val;

void setup()  
{
  Serial.begin(9600);
  mySerial.begin(19200);
} 

void loop() 
{
  if (mySerial.available())
   {
        label = mySerial.readStringUntil('\t');      
        val = mySerial.readStringUntil('\r\r\n');
        Serial.println(label + val);
   } 
}