BirdNET-Pi Bencheng

Introduction

For help just search for mediawiki formatting

Configuration of Raspberry Pi

To include photo - just click on Upload file on the left Upload file / image Then copy file name and place here using following format...

• Step 1: Download the Raspberry Pi Imager

Download link: https://www.raspberrypi.com/software/

• Step 2: Insert the sim card into the adapter and plug it into the computer.

• Step 3: Choose Raspberry Pi OS Lite(64-bit) as the Operating System.

• Step 4: Choose storage space

(If nothing is available it’s because the sim wasn’t recognized. Unplug it and insert again.)

• Step 5: Advanced Options

Click the gear icon at the right bottom of the interface.

  - Step 5.1 Set username and password
   
  Here we set the username and password of the Raspberry Pi. They will be used in later steps so remember to take notes of them lest you forget.
  
  - Step 5.2 Configure wireless LAN

   This is where you specify the WIFI that is going to be connected to Raspberry Pi. These specifications can be altered later.

(Note that you must choose the Wireless LAN country to be the country you are currently in.)

  - Step 5.3 Set locale settings

   Choose the right time zone and set the Keyboard layout as “us”.

• Step 6: Once the above steps are finished, click “write” on the right of the interface.

The writing and verification process takes a few minutes.

Another section

tar -xvf arduino-1.8.19-linuxarm.tar.xz
adad
fa
f
sd
fs
adf
asd
f
sdf