BirdNET-Pi Bencheng: Difference between revisions
Jump to navigation
Jump to search
| Line 37: | Line 37: | ||
- Step 5.1 Set username and password | - Step 5.1 Set username and password | ||
Here we set the username and password of the Raspberry Pi. They will be used in later steps so remember to take notes of them lest you forget. | |||
- Step 5.2 Configure wireless LAN | |||
[[File:Rasp_Step_5. | [[File:Rasp_Step_5.2.png | 450px]] | ||
This is where you specify the WIFI that is going to be connected to Raspberry Pi. These specifications can be altered later. | |||
(Note that you must choose the '''Wireless LAN country''' to be the country you are currently in.) | |||
- Step 5.3 Set locale settings | - Step 5.3 Set locale settings | ||
[[File:Rasp_Step_5.3.png | 450px]] | [[File:Rasp_Step_5.3.png | 450px]] | ||
Choose the right time zone and set the Keyboard layout as “us”. | |||
= Another section = | = Another section = | ||
Revision as of 03:18, 27 July 2023
Introduction
For help just search for mediawiki formatting
Configuration of Raspberry Pi
To include photo - just click on Upload file on the left Upload file / image Then copy file name and place here using following format...
- Step 1: Download the Raspberry Pi Imager
Download link: https://www.raspberrypi.com/software/
- Step 2: Insert the sim card into the adapter and plug it into the computer.
- Step 3: Choose Raspberry Pi OS Lite(64-bit) as the Operating System.
- Step 4: Choose storage space
(If nothing is available it’s because the sim wasn’t recognized. Unplug it and insert again.)
- Step 5: Advanced Options
Click the gear icon at the right bottom of the interface.
- Step 5.1 Set username and password Here we set the username and password of the Raspberry Pi. They will be used in later steps so remember to take notes of them lest you forget. - Step 5.2 Configure wireless LAN
This is where you specify the WIFI that is going to be connected to Raspberry Pi. These specifications can be altered later.
(Note that you must choose the Wireless LAN country to be the country you are currently in.)
- Step 5.3 Set locale settings
Choose the right time zone and set the Keyboard layout as “us”.
Another section
tar -xvf arduino-1.8.19-linuxarm.tar.xz
adad
fa
f
sd
fs
adf
asd
f
sdf